Skip to main content
Skip table of contents

[ADMIN FAQ] How do I configure a signature handler for sealing logs?

Since the 4.52 version of MOXIS, it has been possible to configure your own signature handler for sealing logs. This article shows you the best way to proceed with the configuration.

Step 1: Step-by-step instructions: Setting up the signature handler for sealing logs

Step 1: To set up the signature handler, please access the administration area and process management and open the process that you want to configure.

Step 2: Navigate to the Signature tab and open the drop-down menu in the Select protocol signature provider section (see Figure 1 [1]). Here you can currently (as of February 2025) choose between two options

  • Timestamp

  • XiTrust Seal (A-Trust)

01a_Signature_handler.png

Figure 1: Select protocol signature provider in process management

XiTip 
By default, an Estonian time stamp certificate is used for new installations. If you want to use your own certificate for this, this can be configured separately by our support team when the new certificate is created. In this case, please get in touch with your XiTrust contact person.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.